Tormach AF50+ - Page 52

10: TROUBLESHOOTING
©Tormach® 2024
Specifications subject to change without notice.
Page 52 UM10825: AF50+ Autofeed Bandsaw Operator's Manual (Version 0324A)
For the most recent version, see tormach.com/support
You May Need
To...
Probability How-To Steps Need More?
Align the guide
bearings.
Low Verify that the guide bearings are correctly aligned. If
they're not, adjust them.
For information, see "Mechanical
Adjustments" (page67).
Use a high-
quality blade.
Low Verify that you're using a high-quality blade. If you're
not, you may need to choose a new blade.
For information, see "Choose a
Blade" (page30).
Follow the blade
break-in
procedure.
Low To maximize blade life, you must follow the procedure
to break in the blade.
For information, see "Break in the
Blade" (page33).
Adjust the
clamping
pressure.
Low During automatic operation, verify that the clamp
pressure regulator isn't set too low: increase the
pressure, and then do a test cut. Examine the behavior
of the machine as it cuts.
For information, see "Change the
Clamping Pressure" (page35).