10: TROUBLESHOOTING
©Tormach® 2024
Specifications subject to change without notice.
Page 76 UM10825: AF50+ Autofeed Bandsaw Operator's Manual (Version 0324A)
For the most recent version, see tormach.com/support
4. Loosen the four M8 socket head cap screws securing the fixed clamp jaw to the infeed table.
Figure 10-18: M8 socket head cap screws on the fixed clamp jaw.
5. Secure the stock to the fixed jaw with a clamp.
6. Tap the fixed clamp jaw until it is flush with the side of the stock.
7. Tighten the four M8 socket head cap screws that you loosened in Step 4. Verify that the fixed clamp jaw remains flush with the
stock.
8. Remove the clamp from the machine.
9. Remove the stock from the machine.
To Next Page
Loading...
