4-21Z Master Z597 Diesel Service Manual
4
HYDRAULIC SYSTEM
Fig 190 DSC-2396
4. Apply a thread locking compound to the hex set
screws and tighten both screws (Fig. 190).
5. Install the fan motor mount to the fan mounting plate
(Fig. 191).
Fig 191 DSC-2380
6. Install the 4 bolts and nuts that retain the fan motor
mount to the fan mounting plate.
Note: Make sure the mounting tab on the fan motor
mount is facing toward the left rear of the
unit. Before tightening the bolts and nuts,
make sure the fan is centered in the middle
of the fan shroud. Tighten the bolts and nuts
(Fig. 192).
Fig 192 DSC-2404
A
A. Mounting tab
Fig 193 DSC-2378
7. Install the hydraulic lines to the hydraulic fan motor
and tighten (Fig. 193).
To Next Page
Loading...
