e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 8
4.2.4 Bypass feed copying
1) Insert a paper into the bypass tray.
→ Bypass paper sensor (S35) is turned ON.
- “Ready for bypass feeding” is displayed.
→ Carriages move to the home position.
2) Press the [START] button ON
→ “Ready for bypass feeding” changes to “COPYING”.
→ Exposure lamp (EXP) ON
→ Scan motor (M1) ON→Carriages-1 and -2 move forward.
→ Main motor (M6), transport motor (M9), developer motor (M11) and exit motor (M7) turned ON
- The drum, fuser unit, developer unit and exit roller are driven.
→ Drum cleaner brush motor (M8) turned ON.
3) Bypass feeding
→ Fans rotate in high speed.
→ Bypass feed clutch (CLT6) turned ON.
- The bypass pickup roller is lowered.
- The bypass pickup roller, feed roller and separation roller start to rotate.
→ Aligning operation
→ Paper reaches the registration roller.
→ After a certain period of time, the bypass feed clutch (CLT6) turned OFF.
4) Hereafter, operations (3) through (6) of “4.2.3. Drawer feed copying” are repeated.
4.2.5 Interruption copying
1) Press the [INTERRUPT] button
→ LED “INTERRUPT” is turned ON.
→ Copying operation in progress is temporarily stopped, and the carriages-1 and -2 return to appro-
priate positions.
→ “Job interrupted job 1 saved” is displayed.
→ Automatic density and reproduction ratio 100% are set. Set number remains the same.
2) Select the desired copy condition
3) After interruption copying is finished:
→ “Press interrupt to resume job 1” is displayed.
→ LED “INTERRUPT” is turned OFF by pressing the [INTERRUPT] button, and the equipment
returns to the status before the interruption.
→ “Ready to resume job 1” is displayed.
4) Press the [START] button
The copying operation before the interruption is resumed.
To Next Page
Loading...
