2
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
OUTLINE OF THE MACHINE
2 - 33
2.6 Disassembly and Replacement of PC boards/HDD
Note:
When the PC board/HDD is replaced, refer to the respective Notes and Cautions of "Replace-
ment of PC boards and HDD" in Chapter 5.3 of the Service Handbook.
[A] HDD cooling fan (M21)
(1) Take off the rear cover-1 ( P.2-31 "[R]
Rear cover-1").
(2) Disconnect 1 connector. Release the har-
ness from the harness clamp.
Fig. 2-43
(3) Loosen 11 screws and take off the SYS
board cover.
Fig. 2-44
(4) Disconnect 1 connector. Remove 2 screws
and take off the HDD cooling fan.
Fig. 2-45
SYS board cover
HDD cooling fan
To Next Page
Loading...
