Toshiba e-studio281c - Page 54

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 34
[B] Hard disk (HDD)
[C] SYS board (SYS)
(1) Take off the rear cover-1 ( P.2-31 "[R]
Rear cover-1").
(2) Take off the SYS board cover ( P.2-33 "[A]
HDD cooling fan (M21)").
(3) Disconnect 2 connectors.
Fig. 2-46
(4) Remove 1 screw and the ground wire.
Remove 4 screws and take off the hard disk.
Fig. 2-47
(1) Take off the SYS board cover ( P.2-33 "[A]
HDD cooling fan (M21)").
(2) Disconnect 2 connectors, remove 2 screws,
and then take off the hard disk with the stay.
Fig. 2-48
Hard disk
Hard disk