e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SPECIFICATIONS/ACCESSORIES/OPTIONS/SUPPLIES
1 - 8
1.3 Options
Notes:
1. The bridge kit (KN-3511) is necessary for installation of the finisher (MJ-1022, MJ-1023,
MJ-1024 or MJ-1101).
2. The finisher (MJ-1023 or MJ-1024) is necessary for installation of the hole punch unit
(MJ-6004N/E/F/S).
3. The finisher (MJ-1101) is necessary for installation of the hole punch unit (MJ-6101N/E/F/S).
4. The PCI slot (GO-1060) is necessary for the installation of the scrambler board (GP-1040)
and the parallel interface kit (GF-1140).
5. The antenna (GN-3010) is necessary to enable the wireless LAN module (GN-1040/1041)
and the bluetooth module (GN-2010).
6. Up to 1 antenna (GN-3010) can be connected to the wireless LAN module (GN-1040/1041).
7. When the wireless LAN module (GN-1040/1041) and the bluetooth module (GN-2010) are
installed together, only 1 antenna (GN-3010) can be connected to each.
Platen cover KA-3511PC / -C
Reversing Automatic Document Feeder (RADF) MR-3018
Drawer module MY-1021 / -C
Paper Feed Pedestal (PFP) KD-1011 / -C
Large Capacity Feeder (LCF) KD-1012 A4/LT / A4-C
Hanging Finisher MJ-1022 / -C
Finisher MJ-1023 / -C
MJ-1101
Saddle Stitch Finisher MJ-1024 / -C
Hole punch unit MJ-6004 N/E/F/S / E-C (for MJ-1023/1024)
MJ-6101 N/E/F/S (for MJ-1101)
Staple cartridge STAPLE-1600 (for MJ-1022)
STAPLE-2000 (for MJ-1023/1024)
STAPLE-600 (for saddle stitcher of MJ-1024)
STAPLE-2400 (for MJ-1101)
Bridge kit KN-3511 / -C
Work table KK-3511 / -C
Damp heater kit MF-3511U/E
FAX unit GD-1200 NA/AU/AS/EU/C/TW
2nd line for fax unit GD-1160 NA/EU-N/C/TW
128 MB Expansion memory GC-1181
512 MB Expansion memory GC-1230
Wireless LAN module GN-1040/1041
PCI slot GO-1060
Scrambler board GP-1040
Bluetooth module GN-2010
Antenna GN-3010
Parallel interface kit GF-1140
Data overwrite kit GP-1060
e-BRIDGE ID Gate (HID iClass) KP-2004
e-BRIDGE ID Gate (MIFARE) KP-2005
Desk MH-1700
Harness kit for coin controller GQ-1020
08/04
To Next Page
Loading...
