Toshiba e-studio281c - Disassembly and Replacement

9
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
DRIVE SYSTEM
9 - 9
9.5 Disassembly and Replacement
[A] Developer motor drive unit
(1) Take off the rear cover-2 ( P.2-32 "[S] Rear
cover-2").
(2) Take off the LGC board case
( P.2-38 "[F] LGC board case").
(3) Take off the SYS board case
( P.2-35 "[D] SYS board case").
(4) Take off the switching regulator unit
( P.2-39 "[G] Switching regulator unit").
(5) Remove 3 screws and take off the flywheel.
Fig. 9-7
(6) Remove 2 screws and take off the bracket.
Fig. 9-8
(7) Open the mylar sheet.
(8) Release the harness from 2 harness clamps.
Fig. 9-9
Flywheel
Bracket
Mylar sheet