Toshiba e-studio281c - 3.13.6 Adjustment of the upper tray angle

16
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16 - 9
16.5.4 Relation between system configuration and IH output
for NAD, SAD, TWD:
for ASU, ASD, AUD, MJD, CND, KRD:
* RADF: Reversing automatic document feeder, FIN: Finisher, HPU: Hole punch unit, LCF: Large
capacity feeder, FAX: FAX unit
(*1) The wattage lowers 50 W more when the scanning is performed from the RADF during warming
up.
(*2) AC power should be input voltage when the equipment is warming up (The lower the voltage is, the
longer the warming up time becomes).
System configuration
Warming up
(*2)
Ready Printing
Energy sav-
ing mode
Automati-
cally OFF
Warming
up time
Equipment only
1160-1300W
800W
1080W
800W OFF
Approx
40 sec.
Equipment and
RADF
(*1)
1020W
Equipment, RADF
(*1)
and FIN
1160-1260W 960W
Equipment, RADF
(*1)
,
FIN, and HPU
Equipment, RADF
(*1)
,
FIN, HPU and LCF
1140-1240W 940W
Equipment, RADF
(*1)
,
FIN, HPU, LCF and FAX
System configuration
Warming up
(*2)
Ready Printing
Energy sav-
ing mode
Automati-
cally OFF
Warming
up time
Equipment only
1160-1300W
700W
1240W
700W OFF
Approx
40 sec.
Equipment and
RADF
(*1)
1180W
Equipment, RADF
(*1)
and FIN
1160-1260W 1120W
Equipment, RADF
(*1)
,
FIN, and HPU
Equipment, RADF
(*1)
,
FIN, HPU and LCF
1140-1240W 1100W
Equipment, RADF
(*1)
,
FIN, HPU, LCF and FAX