Toshiba e-studio281c - Disassembly and Replacement

10
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
PAPER FEEDING SYSTEM
10 - 9
10.6 Disassembly and Replacement
[A] Bypass unit
[A-1] Bypass unit
(1) Take off the right front hinge cover
( P.2-28 "[I] Right front hinge cover").
(2) Take off the right rear hinge covers
( P.2-31 "[P] Right rear hinge cover").
(3) Remove 1 screw of ground wires. Discon-
nect 1 connector and release the harnesses
from 2 harness clamps.
Fig. 10-7
(4) Remove 1 screw (M4*12). Open the bypass
feed tray and take off the bypass feed front
cover.
Fig. 10-8
(5) Remove 1 screw. Open the bypass feed tray
and take off the bypass feed rear cover.
Fig. 10-9
Connector
Ground wire
Bypass feed front cover
Bypass feed rear cover
05/08