e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 10
[A-2] Hinge assembly
(6) Remove 3 screws. Lift up the bypass unit
and take it off toward you.
Note:
When installing the bypass unit, make sure
that the ADU is closed in advance since the
bypass unit occasionally does not slide
smoothly.
Fig. 10-10
(1) Take off the bypass unit ( P. 1 0 - 9 " [ A - 1 ]
Bypass unit").
(2) Disconnect 1 connector and release the har-
ness from the harness clamp.
Fig. 10-11
(3) Remove 2 screws and slide the hinge
assembly to take it off with the tray.
Fig. 10-12
Bypass unit
Connector
Tray
Hinge assembly
05/08
To Next Page
Loading...
