e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
CONTROL PANEL
5 - 4
5.2.2 Message
No. Message State of equipment Note
1 - Power is OFF (at Sleep Mode) Press [START] button or function but-
ton to clear
2 Saving energy -
press START button
At Energy Saving Mode Press [START] button to clear
3 Wait Warming Up Scanner warming up
• Displayed until the equipment
becomes ready to start scanning
Auto Start can be set
4 Wait Warming Up
Auto Start
Scanner warming up
• Displayed when Auto Start is set
Press [STOP] button to clear the
Auto Start.
5 WAIT Displayed when performing the con-
trolling function such as cleaning of
2nd transfer roller or main charger to
keep the equipment at the best con-
dition
6 Wait adding toner Supplying toner
• Equipment becomes the toner
supply state
Recovers when the toner supply has
finished
7 Performing Auto Calibra-
tion
Displayed at image quality control Recovers when the image quality
control has finished
8 READY Ready for copying
• Waiting for the operation
9 READY
Press START button to
copy
Copying job interrupted Press [START] button to resume
copying or press [MEMORY CLEAR]
button to delete the job
10 READY
(WARMING UP)
Scanner warming up
• Ready to scan the original
11 READY
(PRINTING)
Printing out the data
• Scanning is enabled
12 READY
(ADDING TONER)
Supplying toner
• Scanning is enabled
13 READY
(INNER TRAY FULL)
Inner tray in the equipment is full
• Scanning is enabled
- When the bridge unit is installed
- Resumes printing by removing
papers from the tray
14 READY
(CHECK STAPLER)
No staples in finisher
• Scanning is enabled
Cleared by supplying the staples
15 READY
(CHECK STAPLER)
Stapling jam occurred in finisher
16 READY
(CHECK SADDLE STITCH
STAPLER)
No staples in saddle stitcher
• Scanning is enabled
Cleared by supplying staples
17 READY
(ADD PAPER)
Press JOB STATUS button
No paper in drawer
• Scanning is enabled
Cleared by supplying papers
18 READY
(FINISHER FULL)
Finisher is full of paper
• Scanning is enabled
Resumes printing by removing paper
from the finisher
19 READY
(HOLE PUNCH DUST BIN
IS FULL)
Punching dust box is full
• Scanning is enabled
Resumes printing by removing
punching dust from the dust box
20 READY
(SADDLE STITCH TRAY
FULL)
Saddle stitcher tray is full of paper
• Scanning is enabled
21 READY
(CHANGE DRAWER TO
CORRECT PAPER SIZE)
Incorrect paper size setting
To Next Page
Loading...
