Toshiba e-studio281c - Page 131

5
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
CONTROL PANEL
5 - 5
22 Ready for bypass feeding Paper is set on the bypass tray
23 COPYING At the copying state
24 Auto Start Auto Start is set during printing Cleared by pressing [FUNCTION
CLEAR] button
25 Close Large Capacity
Feeder
LCF drawer is not installed when
feeding from LCF is set
Cleared by installing LCF drawer
26 Close Large Capacity
Feeder Door
LCF cover is open when feeding from
LCF is set
Cleared by closing the cover
27 Place Doc. Feeder in the
down position
RADF is open when original is placed
on RADF
Cleared by closing RADF
28 Place originals in the docu-
ment feeder
Displayed when the conditions are
set and [START] button is pressed
with no original placed
Cleared by setting the original
29 Change direction of original Displayed when the direction of origi-
nal placed is different from the setting
30 Place last %d originals in
doc.
feeder entrance tray
Paper jam occurred during copying
(RADF scanning)
31 Cannot copy this original Displayed when the original which is
not allowed to be copied is placed
Not printed out
32 Add paper Displayed when the paper in
selected drawer is running out
33 Cannot duplex this size Displayed when the paper size which
is not specified for duplex copying is
set
34 Cannot use this media type Displayed when the paper size which
is not specified for the functions such
as stapling or hole punching is set
35 Copy size: A4/LT only Displayed when the paper size which
is not specified for “Book-type duplex
copying” or “Dual-page” is set
36 Copy size: A4/LT and A4-
R/LT-R
Displayed when the paper size which
is not specified for “Rotate Sort”
37 CHANGE DRAWER TO
CORRECT PAPER SIZE
Displayed when the selected paper
size is not in the drawer
38 Change drawer to correct
media type
Displayed when the selected media
type is not in the drawer
39 Select a paper size for
bypass feeding
Displayed when paper size needs to
be specified for bypass feeding such
as duplex copying
40 Place the blank sheets in
bypass tray and select the
paper size
Displayed when no paper is in the
selected feeder at Cover Copying
Mode
41 Place the blank sheets in
the same direction as the
originals
Displayed when the direction of
cover page is different from that of
other pages at Cover Copying Mode
42 Place the same size blank
sheets as the originals
Displayed when the paper size of
cover page is different from that of
other pages at Cover Copying Mode
43 Place insertion sheets in
the bypass tray and select
the paper size
Displayed when no insertion sheet is
in the selected drawer at Sheet Inser-
tion Mode
44 Select the same size
insert1 sheets as the origi-
nals
Displayed when the size of insertion
sheet (sheet 1) is different from that
of other pages at Sheet Insertion
Mode
No. Message State of equipment Note