Toshiba e-studio281c - Disassembly and Replacement

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
AUTOMATIC DUPLEXING UNIT (ADU)
17 - 12
17.7 Disassembly and Replacement
[A] Automatic Duplexing Unit (ADU)
(1) Take off the right front hinge cover.
( P.2-28 "[I] Right front hinge cover")
(2) Take off the right rear hinge cover.
( P.2-31 "[P] Right rear hinge cover")
(3) Remove 1 screw (M4*12), open the bypass
tray and take off the bypass feed front cover.
Fig. 17-8
(4) Disconnect 1 connector and remove 1 screw
fixing the ground wires.
(5) Remove 2 screws and take off the bracket.
Fig. 17-9
(6) Open the ADU. Lift up the ADU a little and
slide it to the rear side and take it off.
Fig. 17-10
Bypass feed front cover
Connector
Bracket Ground wire
Screw
Screw
ADU