16
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16 - 1
16. FUSER UNIT / PAPER EXIT SECTION
16.1 General Description
Toner is fused by applying heat and pressure on the transferred image on the paper which is trans-
ported to the fuser unit. The paper is then transported to the inner tray, paper exiting options or ADU.
The fuser unit consists of the IH coil (IH-COIL), fuser roller, pressure roller, fuser belt, separation roller,
separation fingers, separation plate, cleaning roller, oil roller, thermistors (THM1, 2, 3), thermostat
(THMO1), exit roller, exit sensor (S40), discharge brush, etc.
Fig. 16-1
Exit roller
Exit sensor
Separation plate
Cleaning roller
Oil roller
Fuser roller
Thermostat
Thermistor
IH coil Pressure roller
Separation finger
Fuser belt
Separation roller
Discharge brush
05/08
To Next Page
Loading...
