Toshiba e-studio281c - Outline of 2 Nd Transfer

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TRANSFER UNIT
14 - 6
14.5 Outline of 2nd transfer
1) The 2nd transfer roller stays at the released position from the transfer belt in 1st transfer.
2) Upon the completion of 1st transfer, the 2nd transfer roller moves to the transfer position.
3) After an electrode bias is applied on the 2nd transfer roller, the toner image is transferred from the
transfer belt to the paper.
4) Upon the completion of 2nd transfer, the 2nd transfer roller escapes to the releasing position.