Toshiba e-studio281c - 3.13 Adjustment of the Finisher (MJ-1022); 3.13.1 Adjusting the jogging plate width

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
FUSER UNIT / PAPER EXIT SECTION
16 - 2
16.2 Construction
Fuser unit
IH coil (IH-COIL)
Fuser roller
Discharge brush PM parts
Pressure roller PM parts
Separation finger PM parts
Fuser belt unit Fuser belt PM parts
Fuser belt guide PM parts
Separation roller
Separation plate
Cleaning unit Oil roller PM parts
Cleaning roller PM parts
Thermistor (THM1, 2, 3)
Thermostat (THMO1)
Exit roller
Exit sensor (S40)
Exit motor (M7)
IH control PC board (IH)
IH control board cooling fan (M17)