16
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16 - 19
16.7 Disassembly and Replacement
[A] Fuser unit
[B] Oil roller
(1) Take off the IH terminal cover
( P.2-30 "[N] IH terminal cover")
(2) Disconnect 2 connectors and 4 faston termi-
nals.
Notes:
1. Make sure to hold the plastic part of the
faston terminals when disconnecting
them.
2. Make sure not to connect each terminal to
the wrong position.
Fig. 16-10
(3) Remove 2 screws and take off the fuser unit.
Fig. 16-11
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Open the jam access cover and transport
guide.
Fig. 16-12
RED
(
S
)
BLUE
(
C
)
WHITE
WHITE
Fuser unit
Transport guide
Jam access cover
To Next Page
Loading...
