Toshiba e-studio281c - Functions

17
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
AUTOMATIC DUPLEXING UNIT (ADU)
17 - 3
17.3 Functions
1) ADU motor (M5)
This motor drives the ADU upper, middle and lower transport roller.
2) ADU clutch (CLT7)
This clutch transfers the drive of the ADU motor (M5) to the upper and middle transport roller.
When the ADU clutch (CLT7) is turned ON, the upper and middle transport roller starts rotating.
3) ADU entrance sensor (S38)
This sensor detects input paper of the ADU transportation.
4) ADU exit sensor (S39)
This sensor detects output paper of the ADU transportation.
5) ADU opening/closing switch (S37)
This switch detects whether the ADU is open or not.
6) Upper transport roller / Middle transport roller / Lower transport roller
This roller transports paper into the ADU.