Toshiba e-studio281c - Disassembly and Replacement

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TRANSFER UNIT
14 - 8
14.7 Disassembly and Replacement
[A] Transfer belt unit / Transfer belt cleaning unit
Note:
It is recommended to wear gloves to avoid a direct touch on the belt surface.
(1) Take off the process unit ( P. 11 - 1 0 " [ B ]
Process unit").
(2) Remove 2 screws on the front side.
Fig. 14-3
(3) Remove 2 screws (shoulder screw) on the
rear side.
(4) Disconnect 1 connector on the rear side.
Fig. 14-4
(5) Take off the transfer belt.
Note:
When the transfer belt unit is being installed,
screw the unit by pressing it downward.
Fig. 14-5
Connector
Transfer belt unit
05/08