Toshiba e-studio281c - Page 55

2
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
OUTLINE OF THE MACHINE
2 - 35
[D] SYS board case
(3) Disconnect 4 connectors. Remove 2 harness
clamps.
Fig. 2-49
(4) Remove 8 screws, and then take off 2 leaf
springs and the SYS board.
Fig. 2-50
(1) Take off the rear cover-2 ( P.2-32 "[S] Rear
cover-2").
(2) Take off the right rear cover ( P.2-30 "[O]
Right rear cover").
(3) Take off the SYS board cover ( P.2-33 "[A]
HDD cooling fan (M21)").
(4) Loosen 2 screws and take off the PS cover.
Leaf spring
PS cover