Toshiba e-studio281c - Page 52

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 32
[S] Rear cover-2
[T] Upper rear cover
(2) Remove 2 screws and take off the rear
cover-1.
Fig. 2-40
(1) Take off the rear cover-1 ( P.2-31 "[R]
Rear cover-1").
(2) Remove 3 screws and take off the rear
cover-2.
Note:
Disconnect the connector of the RADF first
when the RADF is installed.
Fig. 2-41
(1) Take off the RADF or the platen cover.
(2) Take off the left rear cover ( P.2-29 "[M]
Left rear cover").
(3) Take off the right rear cover ( P.2-30 "[O]
Right rear cover").
(4) Remove 2 screws and take off the upper rear
cover.
Fig. 2-42
Rear cover-1
Rear cover-2
Upper rear cover