Toshiba e-studio281c - Page 118

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 12
(C) Misfeed in equipment
• Exit sensor (S40) detects jamming of the leading edge of paper

Registration clutch turned ON
Fig. 4-1

Approx 1.2 sec.
Exit sensor (S40) turned ON
If the exit sensor (S40) is not turned ON after
approx 1.2 seconds,

Paper jam (E010)  The copying operation
is stopped.
• Exit sensor detects jamming of the trailing edge of paper
Registration clutch (CLT12) turned OFF
Fig. 4-2

Approx 1.3 sec.
Exit sensor (S40) turned OFF
If the exit sensor (S40) is not turned OFF after
approx 1.3 seconds,

Paper jam (E020)  The copying operation
is stopped.
• Immediately after the power ON

Any of all sensors on paper transport path detects paper (ON)

Paper jam (E030)
• Front cover is opened during copying

Paper jam (E410)
• Registration sensor (S22) detects jamming of the leading edge of paper:
The registration sensor (S22) is not turned ON in a fixed period of time after the leading edge of
paper passed the transport roller.

Paper jam (E120, E200, E210, E300, E330 and E3C0)
Registration clutch
ON
0
ON
Approx 1.2 sec.
Paper jam
(
E010
)
Exit sensor
Timer
Registration clutch
Exit sensor
Timer
ON
OFF
Approx 1.3 sec.
Paper jam
(
E020
)