e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 14
(G)Call for service
Check the error code displayed on the control panel when “Call for service” appears, and handle the
abnormality in reference to the error code table in Service Handbook.
“Dispose of used toner” is displayed
• Toner bag full detection sensor (S20) is turned ON during printing
Printing is stopped after the paper being printed is exited
Solution: Replace the toner bag with new one and close the front cover.
To Next Page
Loading...
