Toshiba e-studio281c - Page 125

4
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
GENERAL OPERATION
4 - 19
Call for service
Call for service
2nd
transfer roller position
corrected?
F
G
Main charger ON
1st transfer bias ON
Black developer drive clutch ON
Black developer bias
(
AC
)
ON
Black developer lifting clutch ON
Black developer bias
(-)
ON
2nd transfer roller contact clutch ON
2nd transfer bias ON
2nd transfer roller contact clutch OFF
2nd transfer bias OFF
Laser emission
(
black image
)
1st transfer
(
black image
)
Transfer belt cleaner clutch OFF
Transfer belt cleaner auger motor OFF
1st transfer bias OFF
Black developer lifting clutch ON
Black developer bias
(
+150
)
ON
Transfer belt cleaner clutch ON
Toner recovery auger ON
Drum cleaner brush ON
Discharge LED ON
Cleaning blade bias ON
Transfer belt cleaner auger motor ON
Black developer bias
(
AC
)
OFF
Black developer lifting clutch ON
Black developer drive clutch OFF
Black developer bias
(-)
OFF
Main charger OFF
Black
developer position
corrected?
NO
YES
"CEB0"
YES
NO
"CEC0"