e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
CONTROL PANEL
5 - 8
84 Misfeed in copier
Press [HELP]
Paper jam in the equipment
• Displayed when paper jam
occurred in the equipment
Remove the paper in the equipment
according to the messages displayed
on the panel.
85 Call for service Displayed when motor, sensor,
switch, etc. do not work properly
Turn OFF the power and solve the
problem, then turn ON the power.
86 Please try again after
a while
Displayed when the Department
Code can no be keyed in immedi-
ately after power-ON.
Leave it for a while and key in the
code again
87 Set standard size Displayed when the paper size which
is not acceptable is set (depends on
the setting)
Reset the paper size
No. Message State of equipment Note
To Next Page
Loading...
