6
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
SCANNER
6 - 19
[D] Exposure lamp (EXP)
(1) Take off the original glass and front upper
cover ( P.6-17 "[A] Original glass",
P.2-27 "[G] Front upper cover").
(2) Move the carriage-1 to the center position.
Fig. 6-24
(3) Disconnect the connector of the exposure
lamp.
Note:
When disconnecting the connector, pay
attention not to give load to the carriage
frame.
(4) Release the harness from the harness
clamp.
Fig. 6-25
(5) Move the carriage-1 to the position where
the side of the frame is cut out.
Fig. 6-26
To Next Page
Loading...
