6
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
SCANNER
6 - 21
[E] Lens unit
(1) Remove the lens cover ( P.6-17 "[B] Lens
cover").
(2) Disconnect 1 connector and remove 5
screws, then take off the lens unit.
Notes:
1. When installing the lens unit, fix it while
pushing it to the rear direction.
2. For adjustment, refer to “3.9.2 Lens Unit”
in the Service Handbook.
3. Do not touch 6 screws shown with the
arrows when replacing the lens unit.
4. Handle the unit with care. Do not touch
the adjusted area and lens. (Hold the unit
as the right figure.)
Fig. 6-28
Fig. 6-29
Fig. 6-30
Lens unit
To Next Page
Loading...
