6
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
SCANNER
6 - 23
[G] Carriage-1
(1) Take off the original glass, upper rear cover
and front upper cover.
( P.6-17 "[A] Original glass",
P.2-32 "[T] Upper rear cover",
P.2-27 "[G] Front upper cover")
(2) Move the carriage and position the holes of
the carriage to the holes of the frame.
(3) Remove 2 screws and take off the brackets
fixing the carriage-1 to the wire.
Fig. 6-34
(4) Remove the square seal fixing the lamp har-
ness to the base. Disconnect the connector
of the lamp harness from the SLG board.
Fig. 6-35
Connector Seal
07/03
To Next Page
Loading...
