Toshiba e-studio281c - Page 169

6
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
SCANNER
6 - 25
[H] Inverter board (INV)
[I] Carriage wire / carriage-2
Note:
When installing carriage-1, fix the bracket
temporarily at the position (A). Then move it
to the direction (B), push it to the end and fix
securely.
Fig. 6-39
(1) Take off the carriage-1.
( P.6-23 "[G] Carriage-1")
(2) Disconnect 2 connectors. Remove 2 screws
and take off the inverter board.
Fig. 6-40
(1) Take off the carriage-1.
( P.6-23 "[G] Carriage-1")
(2) Attach the wire holder jigs to the pulleys to
prevent the wires from loosening.
Note:
Refer to “3.9 Adjustment of the Scanner Sec-
tion” in the Service Handbook for the direc-
tion of the wire holder jigs.
Fig. 6-41
(
B
)
(
A
)
(
A
)
Inverter board