Toshiba e-studio281c - Page 171

6
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
SCANNER
6 - 27
[K] SLG board (SLG)
[L] Scanner unit cooling fan (M15)
(1) Take off the lens cover.
( P.6-17 "[B] Lens cover")
(2) Disconnect 8 connectors, remove 6 screws
and take off the SLG board.
Fig. 6-45
(1) Take off the upper rear cover.
( P.2-32 "[T] Upper rear cover")
(2) Disconnect 1 connector. Release the har-
ness from the harness clamp. Remove 2
screws and take off the scanner unit cooling
fan.
Fig. 6-46
SLG board
Scanner unit cooling fan