e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DRUM RELATED SECTION
11 - 16
[E] Main charger grid
[F] Charger wire
* Tungsten wire (length: 373 mm, diameter: 0.06 mm)
(1) Take off the grid by pushing the terminal
head on the front side.
Note:
Do not touch the mesh area of the grid.
Fig. 11-24
(1) Take off each terminal cover on both front
and rear sides.
Fig. 11-25
(2) Take off 1 terminal and remove 1 spring.
Then take off the charger wire.
Notes:
When the charger wire is being installed, pay
attention to the following:
1. Insert the each edge of the wire securely
into each V-groove on both front and rear
sides.
2. Do not twist the wire.
3. Do not touch the wire directly with bare
hands.
Fig. 11-26
Grid
Terminal cover
Spring
Charger wire
Terminal
To Next Page
Loading...
