e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TRANSFER UNIT
14 - 10
[B] Transfer belt
Note:
It is recommended to wear gloves to avoid a direct touch on the belt surface.
(9) Take off the transfer belt cleaning unit.
Fig. 14-9
(1) Take off the transfer belt cleaning unit
( P.14-8 "[A] Transfer belt unit / Transfer
belt cleaning unit").
(2) Remove 1 screw and take off the right rail.
Fig. 14-10
(3) Remove 1 screw on the front side and 1
screw on the rear side. Then lay down the
tension roller.
Fig. 14-11
Transfer belt cleaning unit
Right rail
Screw
Screw
Tension roller
To Next Page
Loading...
