Toshiba e-studio281c - Page 363

16
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16 - 21
[C] Cleaning roller
Note:
Install the oil roller according to the marking
on the frame (the shaft end with a groove
should point at the rear side).
Fig. 16-16
(1) Take off the oil roller from the cleaning unit
( P.16-19 "[B] Oil roller").
(2) Remove 1 E-ring and 1 bushing from the
cleaning roller front side. Then take off the
cleaning roller.
(3) Remove the spring (B) on each end of the
frame.
Note:
When installing, make sure that the oil roller
rotates smoothly by turning the gear (C) of
the cleaning roller manually for a several
times.
Fig. 16-17
(4) Remove 1 E-ring, the gear (C) and 1 bushing
from the cleaning roller rear side.
Fig. 16-18
Oil roller
Groove
Cleaning roller
Bushing
Spring
(
B
)
E-ring
Gear
(
C
)
E-ring
Bushing
Gear
(
C
)