16
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16 - 23
[E] Fuser roller / Fuser belt guide
Note:
When installing/disinstalling the fuser
roller, make sure not to remove the spring
(shown in the figure at right) since the
removal of this spring may have the fuser
roller press to deform the thermistor.
Fig. 16-22
(1) Remove the cleaning unit
( P.16-19 "[B] Oil roller").
(2) Remove the IH coil ( P.16-22 "[D] IH coil
(IH-COIL)").
(3) Push down the pressure releasing levers on
both sides.
(4) Remove 1 C-ring and 2 gears.
Fig. 16-23
(5) Remove 1 bearing.
Fig. 16-24
Spring Spring
C-ring
Gear
Pressure releasing lever
Bearing
To Next Page
Loading...
