Toshiba e-studio281c - Page 396

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
AUTOMATIC DUPLEXING UNIT (ADU)
17 - 18
[K] Lower transport roller
[L] ADU entrance sensor (S38)
(1) Take off the ADU board.
( P.17-13 "[D] ADU board (ADU)")
(2) Take off the ADU cover.
( P.17-14 "[E] ADU cover")
(3) Remove 2 clips, 2 pulleys and 2 pins on the
front side. Then take off the timing belt.
Fig. 17-26
(4) Remove 1 clip and 1 bushing on the rear
side.
(5) Remove 1 bushing on the front side. Then
take off the lower transport roller.
Fig. 17-27
(1) Take off the ADU cover.
( P.17-14 "[E] ADU cover")
(2) Disconnect 1 connector. Release the latches
and take off the ADU entrance sensor.
Fig. 17-28
Pin
Pin
Clip
Clip
Pulley
Pulley
Belt
Bushing
Bushing
Clip
Lower transport roller
ADU entrance sensor