Toshiba e-studio281c - 2.2.3 Test print mode (test mode 04)

2
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
OUTLINE OF THE MACHINE
2 - 41
[J] High-voltage transformer (HVT)
[K] FIL board (FIL)
Caution:
Be sure to unplug before the work, not to get an electricshock.
(1) Take off the switching regulator unit
( P.2-39 "[G] Switching regulator unit").
(2) Disconnect 8 connectors.
Fig. 2-66
(3) Remove 2 screws, release 2 lock supports,
and take off the high-voltage transformer.
Fig. 2-67
(1) Take off the rear cover-2 ( P.2-32 "[S] Rear
cover-2").
(2) Take off the right lower cover ( P.2-31 "[Q]
Right lower cover").
(3) Remove 1 screw and take off the cover plate.
Fig. 2-68
High-voltage transformer
Cover plate