4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 7
(5) Take off the top right cove and right upper
cover.
( P.4-2 "4.1.3 Top right cover", P.4-3
"4.1.7 Right upper cover")
(6) Release the harness from the clamp.
(7) Remove 1 screw and take off the clamp.
Fig. 4-18
(8) Remove 4 screws.
(9) Release the harness from the clamp and
then place the control panel unit with its
reverse side up.
When assembling the unit, be sure that the
harness is not caught.
Fig. 4-19
(10) Remove 1 screw, take off 3 clamps and
disconnect 1 connector (with a lock).
(11) Remove 2 screws, take off a USB port and
then the control panel unit.
Fig. 4-20
[1]
To Next Page
Loading...
