Toshiba e-STUDIO656 - Web Motor (M4); Fuser Transport Sensor (S9)

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 107
4.10.11 Web motor (M4) / Fuser transport sensor (S9)
(1) Take off the fuser unit.
( P.4-96 "4.10.2 Fuser unit")
(2) Take off the cleaning web unit.
( P.4-97 "4.10.3 Cleaning web unit /
Cleaning web")
(3) Remove 2 screws to take off the fuser unit
cover (front).
Fig. 4-299
(4) Remove 2 screws and open the lower
separation finger unit.
Fig. 4-300
(5) Release the harness from the harness end-
holder and then disconnect 1 connector.
(6) Remove 2 screws and take off the web
motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
Fig. 4-301
Fuser unit cover (front)
Lower separation finger unit
Web motor