Toshiba e-STUDIO656 - Drum Motor (M11); Motor Driving PC Board (MOT)

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 67
4.7.8 Drum motor (M11) / Motor driving PC board (MOT)
4.7.9 Cleaning brush drive motor (M13) / Drum separation finger
solenoid (SOL1)
(1) Take off the rear cover, SYS board and then
hard disk with its bracket.
(2) Remove 3 screws to take off the drum wheel.
Fig. 4-189
(3) Disconnect 1 connector and remove 3
screws to take off the drum motor with its
bracket.
Note:
When installing the drum motor, tighten the
screw while the bracket is pushed against
the motor in the direction of the arrow.
(4) Remove 3 screws to take off the drum motor.
Fig. 4-190
(1) Take off the exhaust duct.
( P.4-59 "4.6.6 Exhaust duct")
(2) Remove 1 screw and take off the stay.
Fig. 4-191
Drum wheel
Screw
Screw
Drum motor ConnectorScrew
Screw
Stay