e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 10
5.6 Adjustment mode (05)
Procedure 1
Procedure 2
Procedure 3
Procedure 4
Procedure 6
* When the automatic adjustment ends abnormally, error message is displayed.
Items in the adjustment mode list in the following pages can be corrected or changed in the
adjustment mode (05). Turn ON the power with pressing the digital keys [0] and [5] simultaneously
in order to enter this mode.
When the power should be turned OFF, be sure to shut down the equipment by pressing the [ON/
OFF] button for a few seconds.
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[CANCEL]
[Digital key]
*
[FUNCTION CLEAR]
(Key in a value)
[CLEAR]
(Corrects value)
[OK]
or
[INTERRUPT]
(Stores value in RAM)
([FAX]
)
[START]
(Test copy)
*Press [
FUNCTION CLEAR
] to enter minus (-).
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
(Code)
[START]
[OK]
or
[INTERRUPT]
(Value unchangeable)
Value
displayed
()
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[CANCEL]
[UP]
or
[DOWN]
(Adjust a value)
[CLEAR]
(Corrects value)
[OK]
or
[INTERRUPT]
(Stores value in RAM)
([FAX]
)
[START]
(Test copy)
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
*
[FUNCTION CLEAR]
[START]
[START]
[Digital key]
(Sub code)
[CLEAR]
(Corrects value)
[CLEAR]
(Corrects value)
[OK]
or
[INTERRUPT]
*Press [FUNCTION CLEAR] to enter minus (-).
(Key in a value)
Stores value
in RAM
()
[CANCEL]
[START]
([FAX]
)
[START]
(Test copy)
[0][5]
[POWER]
[POWER]OFF/ON
(Exit)
[Digital key]
(Code)
[START]
()
Automatic
adjustment
*[CANCEL] or [CLEAR]
([FAX]
)
[START]
(Test copy)
To Next Page
Loading...
