Toshiba e-STUDIO656 - Upper Separation Finger Unit; Upper Separation Finger

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 101
4.10.5 Upper separation finger unit / Upper separation finger
(4) Open 2 clamps and remove 2 connectors.
(5) Remove 2 screws and take off the bracket.
Fig. 4-281
Note:
When installing the bracket, be sure that the
harnesses are not caught.
(6) Pull out the IH coil.
Note:
When installing the IH coil, be sure that the
marks "C" and "S" of the power supply
harnesses come at the left side.
Fig. 4-282
(1) Take off the fuser unit.
( P.4-96 "4.10.2 Fuser unit")
(2) Take off the cleaning web unit.
( P.4-97 "4.10.3 Cleaning web unit /
Cleaning web")
(3) Remove 2 screws to take off the fuser unit
cover (front).
(4) Remove 2 stepped screws. Then take off the
upper separation finger unit and a crank
bracket by sliding them to the rear side.
Fig. 4-283
Bracket
Clamp
Connector
Screw
IH coil
C
(
Blue
)
S
(
Red
)
Black
Crank plate
Upper separation finger unit
Screw Screw