Toshiba e-STUDIO656 - Adjustment of LCF (MP-4004)

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
6 - 102
6.19 Adjustment of LCF (MP-4004)
6.19.1 Sheet sideways deviation adjustment
When the center of the printed image shifts to the front side or rear side, adjust the tray position taking
the following procedure.
<Procedure>
(1) Pull out the tray unit.
(2) Loosen 3 screws and move the adjustment board to the right position. Then screw it shut.
Fig. 6-120
• The center of the printed image shifts to the front side:
Move the adjustment board to the front side (Arrow (B) in the upper figure).
Fig. 6-121
AB
Adjustment board
Feeding direction
Center
[
Rear
]
[
Front
]