Toshiba e-STUDIO656 - Exit Roller

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 112
4.11.7 Exit roller
4.11.8 Reverse section driving unit / Reverse motor driving PC board
(MOT2-RV board)
(1) Take off the exit/reverse unit.
( P.4-109 "4.11.1 Exit/Reverse unit")
(2) Remove the E-ring, gear and pin.
(3) Remove 2 E-rings and take off the exit roller
by sliding 2 bearings to the inside.
Fig. 4-313
(1) Take off the exit/reverse unit.
( P.4-109 "4.11.1 Exit/Reverse unit")
(2) Disconnect 1 connector, remove 6 screws
and then take off the reverse section driving
unit.
Fig. 4-314
(3) Release 4 locking supports to take off the
MOT2-RV board.
Fig. 4-315
Exit roller
Gear
Pin
Reverse section driving unit
Reverse motor driving PC board