Toshiba e-STUDIO656 - Toner Recycle Unit

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 72
4.8.6 Toner recycle unit
(8) Remove 2 E-rings and then 2 gears.
(9) Remove 2 screws to take off the new toner
transport motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
Fig. 4-203
(1) Take off the toner cartridge drive unit.
( P.4-69 "4.8.1 Toner cartridge drive unit")
(2) Remove 2 screws to take off the left inner
cover.
(3) Disconnect 1 connector, remove 2 screws,
and then take off the toner recycle unit.
Fig. 4-204
Notes:
1. Be extremely careful when handling this
unit because toner may spill out from the
joint with the toner recycle unit, cleaner
unit and developer unit.
2. Install the window of the shutter section
on the toner recycle unit so that it
matches with the protrusion of the
developer unit.
3. Be careful to allow as little vibration as
possible to the unit when installing and
removing the toner recycle unit. Vibration
could cause stains on the image after
assembling, especially when the
remaining toner amount in the cartridge is
small.
Fig. 4-205
New toner transport motor
Gear
Gear
Toner recycle unit
Connector
Protrusion