Toshiba e-STUDIO656 - Functions

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 20
Fig. 5-8
Remark:
If the HDD type cannot be identified, "Unknown HDD" may appear on the screen.
Refer to  P.8-127 " [F106_1] ADI-HDD error: HDD type detection error"
Note:
When "SATA HDD" (normal HDD) is displayed, items 1 and 2 are not selectable. If you select
any of 1 and 2 and press the [START] button, the error message below appears.
Fig. 5-9
5.10.3 Functions
[A] 1. Revert factory initial status HDD
Select this to dispose of the HDD as well as the equipment.
HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
System Firmware Version
Update Mode
: xxxx(x.x.x.x)
: 4c Mode
HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
System Firmware Version
Update Mode
: xxxx(x.x.x.x)
: 4c Mode
=>
Operation Failed.
Press SoftPower Key to Switch Off