Toshiba e-STUDIO656 - Guide Roller on the Front Side

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 76
4.8.12 Guide roller on the front side
4.8.13 Guide roller on the rear side
(1) Take off the developer unit.
( P.4-73 "4.8.8 Developer unit")
(2) Remove 2 screws, take off the bracket and
then remove 3 gears.
Fig. 4-215
(3) Remove 1 E-ring and then the spring.
(4) Remove 2 E-rings and take off 2 guide
rollers.
Fig. 4-216
(1) Take off the developer unit.
( P.4-73 "4.8.8 Developer unit")
(2) Remove 1 E-ring and then the gear.
(3) Remove 1 E-ring, 1 spring and then the
bushing.
(4) Remove 4 screws, the rear side frame and
then disconnect the bias connector.
Fig. 4-217
Bracket
Screw
Screw
E-ring
E-ring
Guide roller
Spring
Bias connector
Spring
E-ring
E-ring
Gear
Bushing
Screw
Screw
Screw