Toshiba e-STUDIO656 - Maintenance Part List

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
7 - 38
7.8 Maintenance Part List
The parts used for the maintenance of this equipment are as follows.
*1: Part list <P-I> represents the page item in (e-STUDIO556/656/756/856 Service Parts List).
No. Item Purpose
Parts list
P-I*
1 Door switch jig Lock of door switch 201-1
2 Cleaning brush Cleaning inside of the equipment 201-2
3 RADF position pin Determining the position of the RADF 201-4
4 Wire holder jig Fixing the wire at the assembly of the
carriage wire
201-5
5 Developer bottle nozzle Pouring the developer material
(attached to the developer bottle)
201-6
6 Belt tension jig Adjusting the belt tension at the
installation of the scan motor
201-7
7 Downloading jig (K-PWA-DLM-320)
Updating the scanner/options ROM
202-1
8 ROM Installing the DLM board 202-2
9 Downloading JIG (PWA-DWNLD-350-JIG1) Updating the system ROM 202-4
10
Downloading JIG (PWA-DWNLD-350-JIG2)
Updating the system ROM) 202-5
11
ROM writer adapter (For 1881)
Writing the data of PWA-DWNLD-350-
JIG1/JIG2
202-2
12
ROM writer adapter (For 1931)
Writing the data of PWA-DWNLD-350-
JIG1/JIG2
202-4
13 Patting pawder For Drum 202-5
14 Drum bag Storing the drum 202-2
15 Color test chart (TCC-2) For test print (A4/LT)j 202-4
16 Color test chart (TCC-3) For test print (A3/LD) 202-5