Toshiba e-STUDIO656 - Exposure Lamp Cooling Fan-2 (M37)

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 18
4.3.9 Exposure lamp cooling fan-2 (M37)
Note:
Rotate the drive pulley to move the carriage.
Fig. 4-49
(3) Disconnect 1 connector.
(4) Remove 3 screws, and take off the Exposure
lamp cooling fan-1.
Note:
When installing the fan, do not tighten the
screw too much.
Fig. 4-50
(1) Take off the original glass.
( P.4-11 "4.3.1 Original glass")
(2) Move the carriage-1 to the right side.
Fig. 4-51
Drive pulley
Exposure lamp cooling fan-1