Toshiba e-STUDIO656 - Exit Sensor [S22]

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 110
4.11.3 Exit sensor [S22]
4.11.4 Reverse sensor-1 [S23] / Reverse sensor-2 [S24]
(1) Take off the left lower cover (= exit cover).
( P.4-4 "4.1.11 Left lower cover (Exit
cover)")
(2) Disconnect 1 connector, remove 1 screw and
then take off the sensor with its bracket.
Fig. 4-307
(3) Release the latch to take off the exit sensor.
Fig. 4-308
(1) Take off the left lower cover (= exit cover).
( P.4-4 "4.1.11 Left lower cover (Exit
cover)")
(2) Disconnect 1 connector, remove 2 screws
and then take off the reverse sensor-1.
(3) Disconnect 1 connector, remove 1 screw and
then take off the reverse sensor-2.
Fig. 4-309
Exit sensor
Exit sensor
Reverse sensor-1
Reverse sensor-2